1 、antistatic agents COLCOAT 515
characteristic
（ 1 ）Lower the static voltage
COLCOAT 515 can not only restrain the static happen, but also can discharge the existent static in a very short time. Compared to the test results of fed method std.no.101b-4046, Colcoat 515 shows excellent static attenuation characteristic according with the military standards (mil-b-81705b).
（ 2 ） the dependence of surface resistance values towards temperature and humidity
The coating surface resistance rate has a close relationship with the environment temperature and the relative temperature. Along with the rapid change of temperature on the surface, the surface resistance rate changes accordingly. From high humidity to low humidity in the environment, the surface resistance rate changes depending on the adaption of environment with time, while the opposite change is in just a few seconds to a few 10 seconds as environment changing. Therefore, it is temperature-dependent, it is high reliability.
（ 3 ）The daily changes of the surface resistance value
The coating surface shows that the surface resistance can be reduced to 10 7 -10 8 ohms. This is important exploitation by Company's R&D department with long-term stability and sustainability of the anti-static spec. In general series of anti-surfactant, it will be effective only for a few months, then the effect disappears; but the colcoat 515 surface resistance value is very stable, it can be maintained for more than two years.
（ 4 ）abrasion resistance
As for the material of plastic (especially the vinyl chloride resin) colcoat 515 is provided with strong gummosity . Although wiped with a cloth, it still shows excellent abrasion resistance and durability. It won't become deterioration phenomenon after using Colcoat 515 on plastic surface commonly.
（ 5 ）
There are free ions, chloride ions in products colcoat 515 under 10ppm, sodium and potassium under 1ppm, so it is not corrosive for IC, LSI and so on, and not harmful towards elements.
（ 6 ） toxicity
According to the Food Sanitation Law, colcoat 515 achieves national standard. Due to an organic solvent, of course, it can not drink.
2 、simple antistatic agents COLCOAT 200 ( liquid)
characteristic
(1) It is methanol solvent , therefore colcoat 200 is fast dry; (2) it has excellent anti-static effect, can reduce the surface resistance of plastic products to 10 8 -10 9 ohms; (3)it can be pre-treatment to prevent bad printing; (4)it has a cleaning capacity, can be used as cleaning agents for plastic products.
3 、water-soluble surface-active type antistatic agents COLCOAT WAS-15X
characteristic
1) Due to water-soluble type, it can be safe used without anti-cracking device; (2) when surface resistance among the 10 8 -10 9 ohms (20 degrees C 55% RH), there will be a superior effect of anti-static
4 、permanent antistatic agents, easy dry COLCOAT N-103X
characteristic
(1) easy drying in normal temperature, the drying time is 10 minutes after finger touched; (2) This agent is different from the surfactants, it will continue to maintain its effectiveness after washing ; (3) siloxane series of anti-static agents; (4) with superior anti-traumatic characteristic for surface, abrasion resistance, weather resistance and strong gummosity ; (5) obtain excellent anti-static effects; (6) After coated Acryl resin, polystyrene resin , multi-carbonate resin and so on, it will increase 2-3% of light transmittance; (7) The agent is absolutely not include harmful aromatic carbon hydride complex.
5 、antistatic coating COLCOAT NR-121X ， COLCOAT NR-121X-9
(1) easy dry in normal temperature, the drying time is 10 minutes after finger touched; If necessary, heat at 40-80 degrees Celsius then dry 10 minutes, the effects are the same; (2) colorless and transparent coating; (3) excellent anti-static effect; (4) in a low humidity environment (25 degrees Celsius 15 % RH) is also able to maintain effectiveness; (5) can be a long time (more than 1 year) lasting effects; (6) superior abrasion resistance, strong gummosity , weather resistant. During the following test, it shows 100% eligible: check-board testing with materials meth acrylic, polystyrene, ABS, polycarbonate, vinyl chloride, polyester film, etc. Testing the peel off with a transparent adhesive tape; (7) because the main ingredient is polymer of organic matter, the non-moving dry film is available according to the ingredients of the friction contact surface;
6 、antistatic water COLCOAT 800 ， COLCOAT 1000
(1) coated on plastic, aluminum platinum bag surface, it forms a thin transparent film, which provides a durable and efficient function of the electrostatic dissipation, it can effectively eliminate the accumulation of static electricity generated by friction, prevent the static interference and dust adhesion, maintain aesthetic and transparent appearance. Even the humidity below 20%, it is still valid. According to using, anti-static performance can keep one month or several months. It is non-toxic, non-polluting, non-corrosive, safe to use, especially suitable for the plastic surface required of static controlled.
In addition: it is also suitable for the desktop, work surfaces, synthetic fiber, glass, plexiglass, electrical enclosure, screen, furniture, carpet, seat cover and the microelectronics industry equipment, and other surfaces which required static controlled.
(2) Surface resistance :10 7 -10 9 ohm
(3) Appearance: transparent liquid at normal temperature storage ( 25 ℃ ): at least one year .........
7 、conductive water
Used on the surface of PP, PET, PS and other plastic sheet, it can be processed into conductive sheets in the printing way, effective, satisfactory results ....
8 、 SJ400-5 SJ400-7 series of super curing agent
It belongs to organic polymers, and a film forms on the surface after used, which has waterproof function, is colorless and transparent, less qty, no effect on the original characteristics of the main material, good light transmission, no corrosion attack to the material, widely used in various types of plastic and other related materials, and good application value to transparent material. The product passes through rigorous environmental testing, and is non-pollution to main material, especially suitable for the exported products. We have been working in anti-static industrial applications field eight years, with extensive experience of anti-static material and market applications, accumulated quite a lot of customers over the years. Along with the adjustment of domestic industrial structure, high-tech enterprise drive high-end electronics progressive, SJ400-5 SJ400-7 series of super curing agent will play an irreplaceable role in the industry.
Use method
●depending on the shape, size, surface state, coat object selects flannel coating, the ink roller coating, roller coating, spray coating, brush coating, dip coating and so on. It is about 30-40 square meters per kilogram.
● strongly inhibit blister, you can use the defoamer when blister occurred during working.
Packaging
● 500CC plastic bottles, 1000CC plastic bottle, 20kg Chemicals plastic bucket
COLCOAT is widely used by Japanese famous manufacturers: Hitachi, Fujitsu, NEC, SONY, PIONEER, Panasonic, Mitsubishi Electric, Seiko homes, Asahi Glass, Toray, Teijin and so on, further more, colcoat is the designated use by partial companies.
